How Do You Put Skirting Boards Over Tiles?

Are you embarrassed about not putting skirting boards over tiles? You may think that the idea of putting your time around your existing grout is a little tacky, but you would be wrong.

Why do you not put your tile on top of the existing grout? 

One of the reasons is that tiles are quite expensive and are also very time consuming to install. When you consider that ceramic skirting tiles are not easy to work with, you might wonder why you don’t want to install them. Well, for one, you may feel that they will be challenging to clean.

If you think that installing these tiles might make it hard for you to clean them, it can be very easy to clean. 

All you have to do is to have some water in a bowl.

Pour some white vinegar into the bowl and set it aside. It will take quite a few hours, but you should be able to get rid of all the grout attached to the tiles. Then, use mild dish soap and water to clean the surface, and then you are ready to go.

Make sure that you use some commercial tile cleaner.

When you are cleaning your tiles’ surfaces, do not just use the same products you use for your walls. Make sure that you use some commercial tile cleaner that will not damage your tiles.

After you have removed the grout from your tile and put white vinegar on the surface, you may now place the tile over the vinegar. Just be careful to apply the tiles to a flat, smooth, and level surface. It will be much better if you use a trowel not to move them when you are tiling the floor.

Rinse the tile off with a soft brush or sponge

If you want to delete the grout, you should rinse the tile off with a soft brush or sponge. There are many commercial tiles that you can buy in different sizes. If you are not sure about the size, you can always measure the grout before buying the tiles.

Finally, you can install your tiles on top of the tiles you bought if you are not comfortable putting them directly on the floor. The good thing about grout is that you can use it again until you are satisfied with your home’s final design.

Use a sealant to protect the tiles.

Now that your tiles are installed and are looking good, you can now use a sealant to protect the tiles. The sealant will prevent water and other elements from penetrating the tiles.

Help to prevent the grout from leaking out of the tiles.

A sealant is very useful in preventing dust and dirt from entering the tiles. It will also help prevent the grout from leaking out of the tiles and into the shower or the tub or onto the tiles around the bathroom.

Make sure to clean and wipe it off after every time.

However, it would be best to keep a sealant on the tiles while you are using it. Make sure to clean and wipe it off after every time you wash or bathe the tiles.


It would be best if you also considered cleaning the tiles before you use the shower or tub. Once you have cleaned it, you should place the sealant on top of the tiles and wait until the water is fully dried.

Make sure that you clean it with water

One of the most important steps in cleaning and maintaining your skirting boards is to make sure that you clean it with water. You can do this by using a glass or ceramic mop. When you use the skirting boards, you should be very careful not to spill anything on it, as this can cause the tiles to crack and break.


Skirting boards are often a lot more expensive than just putting on the tiles in your kitchen. And it’s not always possible to do the whole kitchen with only one board. Sometimes the entire kitchen has to be done before you can put up the board. However, if you’re going to try to do everything in your kitchen before you put up abroad, it will be much easier to move all the tiles around once it is up and ready. 

Leave a Reply

Your email address will not be published.